Underhood Service Advertise | Subscribe | Contact Us | About Us

Cold Engine Stumble, DTC P0116, & MIL ON Panama City FL

Some 2002 1.6L Accents may turn on the Check Engine light and store diagnostic trouble code P0116 (Engine Coolant Temperature Sensor Range/ Performance Problem) in the ECM. This code can be falsely set under certain driving conditions.

Grease Pro
(850) 784-4433, 001-2004
219 Harrison Avenue
Panama City, FL
Emerald Coast Automotive Repair, Inc.
(850) 769-6933, 001-2004
1115 West 15th Sreet
Panama City, FL
Adams Tank & Lift North
(850) 914-0373
Panama City Beach, FL
Coram & Son Tire & Automative Center Inc
850-763-5731
1704 Drake Ave
Panama City, FL
Lloyd Pontiac-Cadillac-GMC Truck
(850) 747-9730
120 E 23rd St
Panama City, FL
Safelite Auto Glass
(888) 820-2558
2808 N East Ave Suite A
Panama City, FL
Adams Tank & Lift North
(850) 914-0373
Panama City, FL
Cylinder Head Service of Panama City
850-769-5520
213 S East Ave
Panama City, FL
Big 10 Tires and Automotive Service Centers
(850) 763-7936
712 W 23rd St
Panama City, FL
Goodyear Auto Service Centers
(850) 763-4651
1001 W 15th St
Panama City, FL
Data Provided by:
 
Provided By:

Cold Engine Stumble, DTC P0116, & MIL ON


October 01, 2005

Some 2000-2002 Hyundai Accents with 1.5L SOHC and 1.6L DOHC engines may experience the following symptoms in hot and humid weather:

  • Slower than usual acceleration after an initial cold start (engine is cold soaked).

  • Greater than usual rpm drop when engaging drive or reverse (on ATM-equipped vehicles) after an initial cold start.

    Some 2002 1.6L Accents may turn on the Check Engine light and store diagnostic trouble code P0116 (Engine Coolant Temperature Sensor Range/ Performance Problem) in the ECM. This code can be falsely set under certain driving conditions. Check the Engine Coolant Temperature (ECT) sensor to make sure that it's functioning properly. When the engine is cold soaked, the ECT and intake air temperature should read approximately the same temperature. When the engine is fully warmed-up, the ECT should read about 190° F to 200° F (depending on the cooling fan cycle). If the code has been set falsely, perform the ECM software reprogramming procedure using the Hi-Scan Pro as outlined below.

    The ECM program has been revised to improve both of the above described conditions.

    Cautions Before Reprogramming:

  • Conduct reprogramming with the ignition key in the "On" position.

  • Be careful not to disconnect any cables connected to the vehicle or Hi-Scan Pro during reprogramming.

    Warning: If reprogramming is interrupted, the manual update procedure must be used.

  • Do not start the engine during reprogramming.

  • ...

    Click here to read the rest of the article from Underhood Service

    © 2009 Babcox
    3550 Embassy Parkway, Akron, OH 44333
    330-670-1234
    (FAX) 330-670-0874