Underhood Service Advertise | Subscribe | Contact Us | About Us

Tech Tip: Kia A/C Compressor Bracket Replacement Denver CO

Some 2002-’05 Sedona (GQ) vehicles may exhibit a humming noise and vibration when the A/C is turned on. To address this condition, replace the A/C compressor bracket with P/N 1K52Y 15810FFF.

B's Auto Inc
(303) 578-4920
1236 E Hampden Ave
Englewood, CO
Fraser's Mobile Garage
(720) 763-8444
1535 Garland ST Unit 2
Lakewood, CO
Roos Only - Subaru's Only
(303) 225-9456
3395 S Federal Blvd
Denver, CO
B J's Auto Theft and Collision Repair
(720) 833-7257
7051 E 56th Ave
Commerce City, CO
DIA Auto Service
(720) 949-7883
7680 Pena Blvd
Denver, CO
Car Care Auto Service
(720) 884-9960
1575 Allison St
Denver, CO
S & A Transmission
(303) 481-6406
2755 W Hampden Ave
Sheridan, CO
Arvada Auto Tech
(720) 763-8226
5395 Marshall St
Arvada, CO
Randy's Tire & Auto
(720) 249-5285
1059 W Littleton Blvd
Littleton, CO
Autotek Auto Repair
(720) 306-7751
7939 E Arapahoe Rd
Greenwood Village, CO
Provided By:

Tech Tip: Kia A/C Compressor Bracket Replacement


May 06, 2009

Some 2002-'05 Sedona (GQ) vehicles may exhibit a humming noise and vibration when the A/C is turned on. To address this condition, replace the A/C compressor bracket with P/N 1K52Y 15810FFF.

Some 2002-’05 Sedona (GQ) vehicles may exhibit a humming noise and vibration when the A/C is turned on. To address this condition, replace the A/C compressor bracket with P/N 1K52Y 15810FFF.

Repair Procedure:
1. Disconnect the negative battery cable.
2. Loosen the three mounting bolts (10 mm) to remove the air intake hose.
3. Loosen one low-side pressure line mounting bracket bolt (10 mm).
4. Connect the A/C charge and recovery system to the vehicle, and recover all R-134a refrigerant from the A/C system.
5. Lift the vehicle off the ground and loosen the 10 mounting bolts (10 mm) to remove the under cover.
6. Remove the right front wheel and wheelhouse shield.
7. Remove the serpentine drive belt by first loosening the center bolt of the pulley.
8. Loosen the adjustment bolt and remove the belt.
9. Remove the idler pulley bracket from the main A/C bracket by removing the three bolts (14 mm).
10. Remove the A/C high- and low-pressure lines from the A/C compressor by loosening two bolts (14 mm).
11. Disconnect the compressor clutch wiring, then remove the compressor from the bracket by loosening four bolts (14 mm).
12. Disconnect the alternator wiring connector and loosen the four bolts (14 mm) to remove the alternator.
13. Loosen the five...

Click here to read the rest of the article from Underhood Service

© 2009 Babcox
3550 Embassy Parkway, Akron, OH 44333
330-670-1234
(FAX) 330-670-0874