Underhood Service Advertise | Subscribe | Contact Us | About Us

Tech Tip: Kia A/C Compressor Bracket Replacement Panama City FL

Some 2002-’05 Sedona (GQ) vehicles may exhibit a humming noise and vibration when the A/C is turned on. To address this condition, replace the A/C compressor bracket with P/N 1K52Y 15810FFF.

Safelite Auto Glass
(888) 820-2558
2808 N East Ave Suite A
Panama City, FL
Adams Tank & Lift North
(850) 914-0373
Panama City, FL
Adams Tank & Lift North
(850) 914-0373
Panama City Beach, FL
Goodyear Auto Service Center
850-763-4651
1001 W 15th St
Panama City, FL
Affordable Body Shop, Inc.
850-913-8808
400 E 15th St
Panama City, FL
Emerald Coast Automotive Repair, Inc.
(850) 769-6933, 001-2004
1115 West 15th Sreet
Panama City, FL
Grease Pro
(850) 784-4433, 001-2004
219 Harrison Avenue
Panama City, FL
Napa Auto Parts
(850) 785-5281
1106 Harrison Ave
Panama City, FL
Chacook Whitehead Ford Inc
850-747-7400
730 W 15th St
Panama City, FL
Goodyear Auto Service Centers
(850) 763-4651
1001 W 15th St
Panama City, FL
Data Provided by:
 
Provided By:

Tech Tip: Kia A/C Compressor Bracket Replacement


May 06, 2009

Some 2002-'05 Sedona (GQ) vehicles may exhibit a humming noise and vibration when the A/C is turned on. To address this condition, replace the A/C compressor bracket with P/N 1K52Y 15810FFF.

Some 2002-’05 Sedona (GQ) vehicles may exhibit a humming noise and vibration when the A/C is turned on. To address this condition, replace the A/C compressor bracket with P/N 1K52Y 15810FFF.

Repair Procedure:
1. Disconnect the negative battery cable.
2. Loosen the three mounting bolts (10 mm) to remove the air intake hose.
3. Loosen one low-side pressure line mounting bracket bolt (10 mm).
4. Connect the A/C charge and recovery system to the vehicle, and recover all R-134a refrigerant from the A/C system.
5. Lift the vehicle off the ground and loosen the 10 mounting bolts (10 mm) to remove the under cover.
6. Remove the right front wheel and wheelhouse shield.
7. Remove the serpentine drive belt by first loosening the center bolt of the pulley.
8. Loosen the adjustment bolt and remove the belt.
9. Remove the idler pulley bracket from the main A/C bracket by removing the three bolts (14 mm).
10. Remove the A/C high- and low-pressure lines from the A/C compressor by loosening two bolts (14 mm).
11. Disconnect the compressor clutch wiring, then remove the compressor from the bracket by loosening four bolts (14 mm).
12. Disconnect the alternator wiring connector and loosen the four bolts (14 mm) to remove the alternator.
13. Loosen the five...

Click here to read the rest of the article from Underhood Service

© 2009 Babcox
3550 Embassy Parkway, Akron, OH 44333
330-670-1234
(FAX) 330-670-0874